PrepAway - Latest Free Exam Questions & Answers

Tag: 640-802

Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in secu

Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?

Which command can be used to verify the DLCI destination address in a Frame Relay static configuration?

Which command can be used to verify the DLCI destination address in a Frame Relay static configuration?

Which three elements must be used when you configure a router interface for vlan trunking?

Which three elements must be used when you configure a router interface for vlan trunking?(choose three)

At which OSI layer did this happen?

A receiving host computes the checksum on a frame and determines that the frame is damaged.The frame is then discarded.At which OSI layer did this happen?

The enable secret command is used to secure access to which CLI mode?

The enable secret command is used to secure access to which CLI mode?

Which two commands can be used to verify a trunk link configuration status on a Cisco switch?

Which two commands can be used to verify a trunk link configuration status on a Cisco switch? (choose two)

Which IP address range meets these requirements?

You are working in a data center environment and are assigned the address range 10.188.31.0/23.You are asked to develop an IP addressing plan to allow the maximum number of subnets with as many as 30 hosts each.Which IP address range meets these requirements?

Which commands are required to to properly configure a router to run OSPF and to add network 192.168.16.0/24 t

Which commands are required to to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (choose two)


Page 23 of 123« First...10...2122232425...304050...Last »