An application uses broadcast traffic to send data to IPv4 hosts. How can the application communicate using IPv6?
A. Anycast
B. Unicast
C. Broadcast
D. Multicast
5 Comments on “How can the application communicate using IPv6?”
maxsays:
I think it is Multicast
1
0
carolocomsays:
For broadcast traffic, IPv4 uses broadcast packets vs IPv6 uses Unicast packets
0
1
Hadessays:
With IPv6 the broadcast addresses are not used anymore, because they are replaced with multicast addressing
1
0
@emresays:
In IPv6, there’s no longer any broadcast – sending one packet to a large number of unspecified hosts. There’s only multicast, unicast and anycast. In IPv6 all nodes are required to support multicast. Without multicast, many services that you need will simply not work. A packet sent to a multicast address is delivered to all interfaces identified by that address.
I think it is Multicast
1
0
For broadcast traffic, IPv4 uses broadcast packets vs IPv6 uses Unicast packets
0
1
With IPv6 the broadcast addresses are not used anymore, because they are replaced with multicast addressing
1
0
In IPv6, there’s no longer any broadcast – sending one packet to a large number of unspecified hosts. There’s only multicast, unicast and anycast. In IPv6 all nodes are required to support multicast. Without multicast, many services that you need will simply not work. A packet sent to a multicast address is delivered to all interfaces identified by that address.
http://ipv6friday.org/blog/2011/12/ipv6-multicast/
I guess the correct answer is (D)
0
0
Besides, part of that new 326Q 200-310 dumps are available here:
http://www.ciscobraindump.com/?s=200-310
Best Regards!
0
0