Refer to the exhibit. Given the partial output of the debug command, what can be determined?
A.
There is no ID payload in the packet, as indicated by the message ID = 0.
B.
The peer has not matched any offered profiles.
C.
This is an IKE quick mode negotiation.
D.
This is normal output of a successful Phase 1 IKE exchange.
Answer will be
This is normal output of a successful Phase 1 IKE exchange.
0
0
Hakan is correct – “D” is the right answer. Search for “Peer matches *none*” on: http://www.cisco.com/en/US/products/hw/routers/ps221/products_configuration_example09186a008073e078.shtml
You’ll see IKE phase 1 still completes successfully.
0
0
Hi Ken
I think it could be “D” if there is e line like: Input = IKE_MESG_INTERNAL, IKE_PHASE1_COMPLETE
Which is not in this case. So I’m still for “B”
0
0
Enko, when I read the comments I initially fully agreed with you. However, I then noticed the “Authenticated” status in the line before the last which meant that the phase 1 negotiation completed successfully, this then proves that Hakan and Ken are right by going with “D”.
0
0