You placed a newly purchased Cisco WiSM in slot 2 of a Catalyst 6504, assigned 172.20.229.61 and 172.20.229.62 to the service ports, but are not able to execute the session slot 2 proc 1 command. After looking at the relevant configuration snippet shown here, what should you do to correct the problem?

C6504#wism service-vlan 123
C6504#show run int vlan 123
!
interface Vlan123
description WiSM Service VLAN
ip address 172.20.229.66 255.255.255.192
end
Select the best response.

Which port must be opened in the firewall if secure mobility tunneling is enabled between two controllers across a firewall?
Select the best response.

A user walks from one building to another where each building has a Cisco WLC 4402 and 50 APs. However, the user does not get a new IP address from the second building’s subnet. What is the reason for this behavior assuming all settings are at defaults? Select the best response.

You have configured WLAN override on an AP to broadcast one out of three WLANs on the Cisco WLC. The Cisco WLC fails and the AP with WLAN override moves to the secondary Cisco WLC. What should you do to ensure that the same SSID is being advertised as before? Select the best response.

You have been asked to create an NAR on the ACS to allow access to a certain SSID for a given user. Which field in the NAR should be configured with the SSID to allow this? Select the best response.

What is the purpose of the AP Groups VLAN feature in the Cisco WLC? Select the best response.

You have two groups, guest and employees, defined in the ACS for wireless authentication. You have a requirement to assign users to different VLANs based on their group membership and
using VSAs. Which action is required for this to happen? Select the best response.

You have decided to have N:N redundancy within your Cisco Unified Wireless Network design. You have two buildings with 24 APs each. What are the "right sized" controllers you would need to achieve this redundancy model?
Select the best response.

Using default AP load balancing behavior, an AP can join one of four candidate controllers:
WLC-one is a Cisco WLC 4402-50 with 28 APs connected. WLC-two is a Cisco WLC 4402-25 with 10 APs connected. WLC-three is a Cisco WLC 4404-100 with 75 APs connected.

WLC-four is a Cisco WLC 4402-12 with 7 APs already joined. Given this loading, and all else being equal, which controller would the next AP join? Select the best response.

How many clients will a Cisco WLC 4402-25 version 5.2 support? Select the best response.