Which three statements describe the OSPF behavior in this scenario?
Which two characteristics of LDP would influence their decision?
A network engineer wants to deploy a VPLS service within the MPLS backbone. The backbone
expert team advises that LDP for signaling is used.
Which two characteristics of LDP would influence their decision? (Choose two.)
Which EoMPLS mode supports this feature?
A network engineer wants to support Ethernet over MPLS and wants to share only a single VC
across the MPLS backbone.
Which EoMPLS mode supports this feature?
Which characteristic of MPLS L3VPN may make it a better option from the Service Provider perspective?
A customer requests that sites are connected over an MPLS backbone using the MPLS AToM
service. However, the network engineer advises that the MPLS L3VPN service may be better for
this situation. Which characteristic of MPLS L3VPN may make it a better option from the Service
Provider perspective?
Which two steps ensure that traffic to the ISP flows through R2 when the network works properly?
R1 and R2 have a static default route that is configured to point toward the ISP. Both R1 and R2
routers redistribute the default route into OSPF. R2 is the primary gateway toward the ISP and R1
is the backup gateway. All link metrics are the same. Which two steps ensure that traffic to the ISP
flows through R2 when the network works properly? (Choose two.)
Which action will fix this problem?
A company is deploying IPv6 using a dual-stack approach. OSPFv2 is used for IPv4 routing and is
redistributed into the BGP IPv4 address family. The network engineer also needs to enable
OSPFv3 for IPv6 routing using the same design that is used for OSPFv2. All prefixes in the
OSPFv3 database must be redistributed into the BGP IPv6 address family at router R2, but R3
does not receive the loopback 0 IPv6 address of R2 via BGP. Which action will fix this problem?
which technique must be used?
A network engineer is tasked with supporting traffic discrimination over MPLS traffic engineering
tunnels. To allocate restricted bandwidth to a certain type of traffic with no QoS degradation, which
technique must be used?
What is the expected output of executing the show ip OSPF neighbor command on the router that is neither a DR
In an OSPF domain, four routers are running the OSPF protocol over a LAN switch in a broadcast
domain. What is the expected output of executing the show ip OSPF neighbor command on the
router that is neither a DR nor a BDR?
What should be done to hide the IP addresses of the Service Provider MPLS core from the customer traceroute ut
A security risk has been discovered on the Service Provider MPLS core network during a network
audit. Traceroute between the customer sites displays IP addresses of the Service Provider MPLS
core. What should be done to hide the IP addresses of the Service Provider MPLS core from the
customer traceroute utility?
Which option describes the minimum LCC and FCC requirements for proper functionality?
An engineer is configuring a Cisco CRS-1 Multishelf System. Which option describes the minimum
LCC and FCC requirements for proper functionality?