In your Cisco EIGRP network, you notice that the neighbor relationship between two of your
routers was recently restarted. Which two of these choices could have made this occur? (Choose
two.)

Your Cisco network currently runs OSPF and you have a need to policy-route some specific traffic,
regardless of what the routing table shows. Which one of these options would enable you to
policy-route the traffic?

You use OSPF as your network routing protocol. You use the command show ip route and you
see several routes described as 0, 0 IA, 0 E1, and 0 E2. What routes are in your area?

What are the mandatory, well-known BGP attributes?

The OSPF RFC 3623 Graceful Restart feature allows you to configure IETF NSF in ultivendor
networks. When using OSPF Graceful Restart, which mechanism is used to continue forwarding
packets during a switchover?

You work as a network engineer for the company, you want to configure two BGP speakers to
form an EBGP session across a firewall. On the engineer’s network, the firewall always permits
TCP sessions that are initiated from the inside network (the network attached to the inside
interface of the firewall). What prerequisite is there for enabling BGP to run on this network?

Two directly connected routers, R1 and -R2, are both configured for OSPF graceful restart. R2 is
able to switch packets in hardware, but R1 is not. If a network administrator logs on to R2 and
performs a system reload, which will be the result?

Which two steps below should you perform on the hub router while configuring EIGRP routing over
DMVPN (mGRE tunnel)? (Choose two.)

Area Border Router (ABR) is a router located on the border of one or more OSPF areas that
connect those areas to the backbone network. An ABR will inject a default route into which two
types of areas? (Choose two.)

Study the exhibit carefully. In this network, if all required configurations are true for routing. Subnet
10.1.1.0/24 is sourced by RA and advertised via BGP, OSPF, and EIGRP. Finally, RG knows this
subnet. Which routing protocol and administrative distance can be used by RG to reach subnet
10.1.1.0/24?