Which item would most likely cause this problem?
A user has no network connectivity. A check of the associated port indicates that the interface is
up, the line protocol is down. Which item would most likely cause this problem?
What should the Bc and Be setting be when using generic traffic shaping?
A router is connected to an HDLC circuit via a T1 physical interface. The SLA for this link only
allows for a sustained rate of 768 kb/s. Bursts are allowed for up to 30 seconds at up to line rate,
with a window Tc of 125 ms. What should the Bc and Be setting be when using generic traffic
shaping?
Which load-balance algorithms can you use in the switch in order to optimize this load balancing?
The EtherChannel between your LAN switch and the Internet router is not load-balancing
efficiently. On the switch, there are several workstations with valid IP ranges. Which load-balance
algorithms can you use in the switch in order to optimize this load balancing? (Choose four.)
Which three combinations are valid LACP or static configurations that will set up a channel?
Which three combinations are valid LACP or static configurations that will set up a channel?
(Choose three.)
Which three combinations are valid PAgP or static configurations that will set up a channel?
Which three combinations are valid PAgP or static configurations that will set up a channel?
(Choose three.)
What impact will this modification on the remote site router have for other existing EIGRP neighborships from
A new backup connection is being deployed on a remote site router. The stability of the connection
has been a concern. In order to provide more information to EIGRP regarding this interface, you
wish to incorporate the “reliability” cost metric in the EIGRP calculation with the command metric
weights 1 0 1 0 1.
What impact will this modification on the remote site router have for other existing EIGRP
neighborships from the same EIGRP domain?
Which configuration should be applied so that the link between R1 and ISP 2 will be preferred for outgoing tra
which one?
Policy-based routing allows network administrators to implement routing policies to allow or deny
paths based on all of these factors except which one?
Which statement is correct about the prefix 160.0.0.0/8?
Which two options does Cisco PfR use to control the entrance link selection with inbound optimization?
Which two options does Cisco PfR use to control the entrance link selection with inbound
optimization? (Choose two.)