What are two differences between the Autonomous WLAN solution and the Lightweight
WLAN solution? (Choose two.)

Refer to the exhibit.

What happens when the switch SW2 is connected to the rest of the
network in the VTP domain Lab_Network?

A campus infrastructure supports wireless clients via Cisco Aironet AG Series 1230, 1240,
and 1250 access points. With DNS and DHCP configured, the 1230 and 1240 access points
appear to boot and operate normally; however, the 1250 access points do not seem to
operate correctly. What is the most likely issue causing this problem?

A standalone wireless AP solution is being installed into the campus infrastructure. The
access points appear to boot correctly, however, wireless clients are not obtaining correct
access. You verify that the local switch configuration connected to the access point appears
as the following:
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem?

Wireless has been operating correctly in the campus infrastructure. After the wireless
controllers are upgraded from LWAPP to CAPWAP, access points no longer boot and
operate normally. What is the most likely issue causing this problem?

A network is deployed using best practices of the enterprise campus network model,
including users with desktop computers connected via IP phones. Given that all components
are QoS-capable, where are the two optimal locations for trust boundaries to be configured
by the network administrator? (Choose two.)

During voice implementation, which two required items are configured at an access layer
switch connected to an IP phone to provide VoIP communication? (Choose two.)

Which two networking infrastructure characteristics are most likely to distinguish video
requirements (such as Cisco TelePresence) from voice requirements? (Choose two.)

Which two items are most important for managing the long-term success of high availability?
(Choose two.)

When planning high availability, which two components are important to minimize the effect
of outages? (Choose two.)