Refer to the exhibit.

For what two reasons has the router loaded its IOS image from the location that is shown?
(Choose two.)

Refer to the exhibit.

What can be determined about the router from the console output?

Which three elements must be used when you configure a router interface for VLAN trunking?
(Choose three.)

Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)

A router receives information about network 192.168.10.0/24 from multiple sources. What will the
router consider the most reliable information about the path to that network?

What is the default maximum number of equal-cost paths that can be placed into the routing table
of a Cisco OSPF router?

Which command shows your active Telnet connections?

Which type of EIGRP route entry describes a feasible successor?

The network administrator cannot connect to Switch1 over a Telnet session, although the hosts
attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic
and assuming that the router and Switch2 are configured properly, which of the following
commands should be issued on Switch1 to correct this problem?

Refer to the exhibit.

Which of these statements correctly describes the state of the switch once the boot process has
been completed?