Refer to the exhibit.

C-router is to be used as a “router-on-a-stick” to route between the VLANs. All the interfaces have
been properly configured and IP routing is operational. The hosts in the VLANs have been
configured with the appropriate default gateway. What is true about this configuration?

Refer to the exhibit.

Why is flash memory erased prior to upgrading the IOS image from the TFTP server?

Which command would you configure globally on a Cisco router that would allow you to view
directly connected Cisco devices?

Refer to the exhibit.

According to the routing table, where will the router send a packet destined for 10.1.5.65?

Refer to the exhibit.

Which address and mask combination represents a summary of the routes learned by EIGRP?

Refer to the exhibit.

Assuming that the entire network topology is shown, what is the operational status of the
interfaces of R2 as indicated by the command output shown?

Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)

Refer to the exhibit.

Given the output for this command, if the router ID has not been manually set, what router ID will
OSPF use for this router?

Refer to the exhibit.

What commands must be configured on the 2950 switch and the router to allow communication
between host 1 and host 2? (Choose two.)

Which two statements describe the process identifier that is used in the command to configure
OSPF on a router? (Choose two.)
Router(config)# router ospf 1