What does the activation-key command in the Cisco ASA do?
What does the activation-key command in the Cisco ASA do?
What will this command do when the system is reloaded?
On a Cisco ASA adaptive security appliance, the administrator enters the
boot config disk0:/startup.txt command. What will this command do when the system is reloaded?
Which three of these commands will show you the contents of flash memory on the Cisco ASA?
Which three of these commands will show you the contents of flash memory on the Cisco ASA? (Choose three.)
Which command or commands should the administrator use to accomplish this?
Refer to the exhibit. An administrator wants to permanently map host addresses on the DMZ subnet to the same host addresses, but a different subnet, on the outside interface. Which command or commands should the administrator use to accomplish this?
Which two configuration modes and commands would the administrator configure when using a pre-shared key of 12
An administrator is configuring a Cisco ASA for site-to-site VPN using pre-shared keys. Which two configuration modes and commands would the administrator configure when using a pre-shared key of 1234? (Choose two.)
Which command will set the default route for an adaptive security appliance to the IP address 10.10.10.1?
Which command will set the default route for an adaptive security appliance to the IP address 10.10.10.1?
Which of the following statements about the configuration of WebVPN on the Cisco ASA is true for Cisco ASA ver
Which of the following statements about the configuration of WebVPN on the Cisco ASA is true for Cisco ASA version 7.2?
Which of these commands enables IKE on the outside interface?
Which of these commands enables IKE on the outside interface?
Which of the following statements about adaptive security appliance failover is true?
Which of the following statements about adaptive security appliance failover is true?
Which two commands should an administrator configure on the security appliance to detect a failure faster?
By default, adaptive security appliances configured for LAN-based failover will fail over after approximately 15 seconds. Which two commands should an administrator configure on the security appliance to detect a failure faster? (Choose two.)