Which implement phase service component consists of explaining the benefits and limitations of purchased support options to a customer and ensuring that the customer understands operational processes and responsibilities?

The customer wants to implement wireless security through implementation of WPAv2. Which component of WPAv2 would limit the rollout because of the continued use of old access points?

What two types of telephony interfaces are used for PSTN connectivity? (Choose two.)

A customer in Europe needs to establish an 11-Mbps wireless bridge link between two office buildings that are approximately 1.3 km apart. The wireless link will pass through a public park, which contains a lake that is surrounded by trees. You run the range calculation and determine that the Cisco Aironet 1300 Series Outdoor Access Point/Bridge should work. You install the link using 10.5-dB yagis with 75 feet of standard Cisco cabling and both radios set at 20 mW. The wireless bridges are not able to establish or maintain a link.

What is needed to successfully complete this link?

A user is unable to connect to the Cisco Router and Security Device Manager via HTTPS. Which two of these might have caused this problem? (Choose two.)

You have just configured HSRP and need to determine which router is active.
Which command should you enter?

The customer wants to implement wireless security through implementation of WPAv2. Which component of WPAv2 would limit the rollout because of the continued use of old access points?

Refer to the exhibit. The tables contain information from the Cisco Router and Security Device Manager configurations of Router A and Router B. Traffic between Host 1 and Host 2 is not successfully establishing the site-to-site VPN between Router A and Router B.

What is the mostly likely cause of this fault?

A user is unable to connect to the Cisco Router and Security Device Manager via HTTPS. Which two of these might have caused this problem? (Choose two.)

Users logging into Cisco Router and Security Device Manager should be authenticated using the Cisco ISR local user database. Currently, none of the users can access Cisco Router and Security Device Manager via HTTP. You should check the configuration of which command or commands when attempting to resolve this problem?