Which three are different types of STP inconsistencies in a Layer 2 network?
Which three are different types of STP inconsistencies in a Layer 2 network?
(Choose three.)
what location is it recommended that the Cisco Catalyst 6500 Series WLSM be placed?
In what location is it recommended that the Cisco Catalyst 6500 Series WLSM be placed?
Which two statements best describe the wireless core feature set using autonomous access points when implement
Which two statements best describe the wireless core feature set using autonomous access points when implementing repeater topology? (Choose two.)
Which two statements are correct about what is displayed?
Refer to the exhibit. Which two statements are correct about what is displayed? (Choose two.)
Which two statements best describe the wireless implementation of Cisco Aironet root and non-root bridging?
Which two statements best describe the wireless implementation of Cisco Aironet root and non-root bridging? (Choose two.)
What is the probable cause of this failure?
You have just configured and enabled the Cisco IOS Firewall feature set from a remote location using the Cisco Router and Security Device Manager (SDM) Firewall wizard. You later want to double-check your configuration using Cisco SDM. However, you find that you can no longer connect to the Cisco IOS Firewall using Cisco SDM.
What is the probable cause of this failure?
What does PVST+ do to correct this?
Refer to the exhibit. Switches A and C are running PVST+ STP, and Switch B is running 802.1Q STP. If the BPDU of the root in VLAN 1 is better than the BPDU of the root in VLAN 2, then there is no blocking port in the VLAN 2 topology. The BPDU of VLAN 2 never makes a “full circle” around the topology; it is replaced by the VLAN 1 BPDU on the B-C link, because B runs only one STP merged with VLAN 1 STP of PVST+. Thus, there is a forwarding loop.
What does PVST+ do to correct this?
Which output might you obtain?
You connect via Telnet to a Cisco access point and enter the command show dot11 linktest. Which output might you obtain?
What is the mostly likely cause of this fault?
Refer to the exhibit. The tables contain information from the Cisco Router and Security Device Manager configuration of Router A and Router B. Traffic between Host 1 and Host 2 is not successfully establishing the site-to-site VPN between Router A and Router B. What is the mostly likely cause of this fault?
What may be causing this issue?
A client is experiencing lower throughput and more packet retransmits in one area of the wireless network. At these times, the client utility shows high signal strength but low signal quality. What may be causing this issue?