Can you implement a complete IPv6 deployment without IPv4 addresses?
A.
No. IPv4 addresses are required for management.
B.
No. SmartCenter cannot be accessed from everywhere on the Internet.
C.
Yes, There is no requirement for managing IPv4 addresses.
D.
Yes. Only one TCP stack (IPv6 or IPv4) can be used at the same time.
Explanation:
CP_R77_ClusterXL_AdminGuide.pdf
page.41
Check Point Appliance or Open Server Wizard
“Important: You must define a corresponding IPv4 address for every IPv6 address. This release
does not support pure IPv6 addresses”
I think the answer is wrong!!!! pls comment it
0
0
IPv6 only is supported :
“Secure pure IPv6 only networks including all gateway IP addresses and management IP addresses.”
http://www.checkpoint.com/products/check-point-ipv6-solutions/
0
0
from sk39374
Is Full HA supported with IPv6?
It is supported with the following limitations:
No IPv6 Dynamic Routing (ClusterXL Limitation in R76 and above)
IPv4 Dynamic Routing is Supported
Dual Stack Only (Full HA requires use of IPv4)
Monitored Interfaces must have IPv4 addresses
Sync traffic is also IPv4
0
0
https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk39374
Can I have a Security Gateway that only runs IPv6?
In R76, it is possible to operate a Security Gateway (regular or VS mode) entirely with IPv6.
In releases prior to R76 releases, Management only occurs over IPv4. In this case, all Security Gateways are required to have interfaces configured with valid IPv4 addresses.
0
0