which setting solves this issue?
What will resolve this problem?
You have deployed Brocade FastIrons for several years in a Power over Ethernet (PoE)
implementation. You computed the power budget for each switch, and determined that there
would be 15.4 watts of power available for each active PoE port with just one power supply in
operation. You configured each PoE port to Class 4. You recently installed new IP phones that use
the updated PoE+ standard. A power supply then failed in one of the switches, and several
phones lost power.
What will resolve this problem?
which two parameters need to be in a disabled state for the link to come up?
When enabling a long distance link connected to a TDM device, which two parameters need to be
in a disabled state for the link to come up? (Choose two.)
Why should you be concerned?
Your installers have installed IP phones on your Brocade FCX HPOE switch. You use show inline
power and notice that there are 802.3at devices in the table.
Why should you be concerned?
How many buffer credits will be allocated for the ports?
You are setting up a long-distance link between site A and site B which are 50 km apart. You are
using 16 Gbps ISL ports on each port between the sites.
How many buffer credits will be allocated for the ports?
what must you do to make the LAG function on a Brocade NetIron MLXe?
Referring to the exhibit, what must you do to make the LAG function on a Brocade NetIron MLXe?
Which statement is true?
You need to run the Diagnostic Port test on a long distance FC link.
Which statement is true?
Which statement is true about configuring this route map?
You have two routers: R1 and R2, running BGP. R1 is peered to ISP1, R2 is peered to ISP2. You
want outbound traffic to use ISP1 and only use ISP2 as a backup. You have created a route-map
using local preference to accomplish this.
Which statement is true about configuring this route map?
Which two statements are true?
You need to run the Diagnostic Port test on a long-distance FC link.
Which two statements are true? (Choose two.)
Which two configuration parameters will correct this issue?
You have an existing network of Brocade MLXes running OSPF between them. You have recently
added 10 Gbps line cards and have connected them between some of the routers, but you have
discovered that traffic is continuing to pass over the slower 1 Gbps links instead.
Which two configuration parameters will correct this issue? (Choose two.)