A user has created a VPC with CIDR 20.0.0.0/16. The user has created public and VPN only subnets along with hardware VPN access to connect to

the user-s datacenter. The user wants to make so that all traffic coming to the public subnet follows the organization-s proxy policy. How can the user make this happen?

A. Setting up a NAT with the proxy protocol and configure that the public subnet rece

ives traffic from NAT

B. Setting up a proxy policy in the internet gateway connected with the public subnet

C. It is not possible to setup the proxy policy for a public subnet

D. Setting the route table and security group of the public subnet which receive

s traffic from a virtual private gateway

Explanation:

The user can create subnets within a VPC. If the user wants to connect to VPC from his own data center, he can setup public and VPN only subnets which uses hardware VPN access to connect wit

h his data center. When the user has configured this setup, it will update the main route table used with the VPN-only subnet, create a custom route table and associate it with the public subnet. It also creates an internet gateway for the public subnet. B

y default, the internet traffic of the VPN subnet is routed to a virtual private gateway while the internet traffic of the public subnet is routed through the internet gateway. The user can set up the route and security group rules. These rules enable the

traffic to come from the organization-s network over the virtual private gateway to the public subnet to allow proxy settings on that public subnet.