A network administrator wants to configure a Comware switch to send HP Intelligent Management
Center (IMC) sFlow samples. Where does a Comware switch direct sFlow samples?

A.
To the multicast address defined for sFlow collector

B.
To the IP address configured as the sFlow agent

C.
To the IP address configured as the sFlowtrap receiver

D.
To the IP address configured as the sFlow collector

Explanation:
sFlow technology is a statistical-sampling–based network monitoring technology for
high-speed switched or routed networks. sFlow technology samples network packets

and sends the samples to a monitoring station. The information gathered by the
sFlow technology is used to create a network traffic visibility picture.
An sFlow monitoring system consists of an sFlow agent embedded in the switch and
a centralized collector. The sFlow agent runs on the switch. It combines interface
counters and flow samples and sends them across the network to the sFlow collector.
Note: CLI Quick Configuration (not the setting of the sFlow collecter IP address on the first line)
To quickly configure sFlow technology, copy the following commands and paste
them into the switch terminal window:
[edit protocols sflow]
set collector 10.204.32.46
set collector udp-port 5600
set interfaces ge-0/0/0.0
set polling-interval 20
set sample-rate 1000
Figure : sFlow Technology Monitoring System