Refer to the exhibit.
The switches shown in the exhibit are HP Comware switches that support FCoE. The servers access the
storage using FCoE. What should be configured on the Ten-GigabitEthernet1/0/1 interface of Switch1?
A.
a QoS policy for Enhanced Transmission Selection (ETS)
B.
the LLDP TLVs for data center bridging extensions (DCBX)
C.
priority flow control (PFC) in manual mode
D.
the LLDP TLVs for Enhanced Transmission Selection (ETS)
Explanation:
http://h10032.www1.hp.com/ctg/Manual/c04088668Page: 253
answer C
There two available configuration modes for PFC. Manual mode is used for switchto-switch links, since switches do not use DCBX to configure each other. Since
there is no negotiation frames sent between switches, each switch must be locally
configured with compatible PFC parameters.
2
0