You have replaced the formatter and transferred the compact flash firmware card from the old
formatter to the newly installed formatter. Then, you power on the printing device.
What do you do after powering up the printing device to a “Ready” prompt?

A.
Wait for all three lights below the control panel to flash 5 times.

B.
Wait five minutes before using the printing device so the printer configuration information can
be restored from the compact flash memory to the NVRAM.

C.
Immediately power cycle the printing device again to make sure the printer configuration was
restored from the compact flash memory to the NVRAM.

D.
Immediately print Diagnostics Page, check the media sensor calibration values and re-enter
through the control panel Service menu, if necessary.