Refer to the exhibits Exhibit 1 This data center topology is being set up to use SPBM. VMs
in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2
from other subnets. VS110010 was created for VLAN 10 as shown in Exhibit 2. The
administrator is configuring a service instance for the VLAN 10 traffic on Switch 1 interface
Ten1/0/1. What is the correct encapsulation mode?

Refer to the exhibit These switches form an SPBM region. What is required for load
balancing to occur across the links between these switches?

To support FCoE traffic, a switch port needs to use Application TLVs to communicate
application priority information to a Converged Network Adapter (CNA). The setup process
includes the configuration of an Access Control List (ACL). What is a valid ACL?

Refer to the exhibit • useOSPF • have established an MPLS domain. • use LDP. • have
established a Martini Layer 2 VPN between Sites 1 and 2 VPN traffic is using the link
between PE-1 and P-4, and this link fails. What happens to the VPN traffic?

An HP Comware switch port is being connected to a server Converged Network Adaptor
(CNA). The CNA and the switch port need to communicate about parameters for various
priority flow control (PFC) and bandwidth control mechanisms. How does the administrator
enable these communications?

Which advantage does a VPLS solution offer over a simple MPLS Layer 2 VPN solution?

An administrator binds VLAN interface 10 to VPN instance “TenantA” on an HP Comware
switch by using this configuration: interface Vlan-interface 10 ip address 10.1.10.1
255.255.255.0 How does the administrator’s action affect the interface IP address?

Multiple data centers connect over an HP EVI network. IPv4 servers in the data centers use
Microsoft network load-balancing and need to send multicasts to each other across EVI
links. They do not use IGMP to join the multicast groups. What must the administrator do?

Refer to the exhibit PE-1 receives an IP packet that is destined to 10 1.10 10 and does not
have an MPLS header. What does PE-1 do?

An administrator configures an HP Comware switch to support FCoE in Fibre Channel
Forwarder (FCF) mode A switch interface connects to a server Converged Network Adapter

(CNA). which sends normal data and storage traffic What is the correct configuration for this
port?