Refer to the exhibit.

A network administrator sends the cURL command shown in the exhibit to an HP VAN SDN Controller team in order to add a region to that team. The
addresses are as follows:
The team IP address is 192.168.56.10.
The team members IP addresses are 192.168.56.14, 192.168.56.15, and 192.168.56.16.

The administrator receives an error in response. How can the administrator fix the configuration?

Refer to the exhibit.

A network administrator is configuring an MPLS and VPLS Martini to connect customer Sites 1, 2, and 3. The administrator has created Virtual Switch
Instance (VSI) “CustomerA” for this purpose. How should the administrator connect customer Site 1 to the VPLS solution?

An HP Comware switch is controlled by a team of HP VAN SDN Controllers. The controllers have these roles within the region that contains the switch.
Controller 1 = Master
Controller 2 Primary slave
Controller 3 =Secondary slave
A failed network connection causes Controller 1 to lose contact with the switch. Controller 2 and Controller 3 can still reach all the controlled devices.
Controller 1 is still up and has contact with other controllers and switches. How does the team handle this situation?

A company is deploying the HP Network Protector SDN Application. The network administrators should be able to see information about user identity in
the Network Protector interface and logs. The log should provide the name of the user on that endpoint.
Which additional component is needed to meet the company’s requirements?

Refer to the exhibit.

The exhibit shows the Fibre Channel (FC) zones that are members of zonesets on an HP Comware switch. How does this zoning affect the FC fabric
operation?

Refer to the exhibits on the Exhibit 1 and Exhibit 2 tabs.
Exhibit 1

Exhibit 2

Three HP switches are controlled by an HP VAN SDN Controller. The exhibits show the topology that the controller has discovered for the switches and
the port status on the 192.168.0.252 switch. All the interswitch links carry the same VLANs.

The 192.168.0.249 switch and the 192.168.0.252 switch also connect on a link that is not shown in the topology. The network administrator wants to
make all of the links between the switches available for SDN applications to use. What should the administrator do to accomplish this?

Which common data center requirement does an HP EVI solution meet?

What is a benefit of the HP Network Protector SDN Application as opposed to a traditional IDS/IPS?

Refer to the exhibits.
Exhibit 1

Exhibit 2

The switch and server will transmit Fibre Channel over Ethernet (FCoE) traffic on the Ethernet link. If congestion occurs, the devices should pause the
FCoE transmissions rather than drop them. What must the network administrator do on interface Ten-GigabitEthernet 1/0/2 to enable this behavior?

An HP Comware switch has four MDCs defined on it. Network administrators need to set up SSH access to each MDC and want to use the
Management-Ethernet interface for that purpose. What is a valid configuration?