What should administrators do to allow administrators t…
A network administrator uses Telnet to log into an HP Comware switch and receives level 0 privileges. The
administrator enters super 3 and receives an error. What should administrators do to allow administrators to
use this command successfully in the future?
Why is the new route missing from the table?
A network administrator enters this command on an HP Comware switch:
The administrator then checks the IP routing table and does not see the new IP route, as shown here:
Why is the new route missing from the table?
What is the correct next hop for the route?
Refer to the exhibit.
A network administrator is creating a route to 10.1.2.0/24 on Switch-4. What is the correct next hop for the
route?
What is the result of this configuration?
Refer to the exhibit.
The exhibit shows the IP routing table for an HP Provision switch. The network administrator then enters these
commands:
What is the result of this configuration?
Which components should the administrator define in ord…
A network administrator is performing auto discovery with Intelligent Management Center (IMC) to discover HP
switches. Which components should the administrator define in order to fully manage the discovered
networking devices?
What should the administrator do to enable IMC to manag…
Refer to the exhibit.
The network administrator wants to permit management access to Switch 2 through Switch 20 for HP Intelligent
Management Center (IMC). The 10 1.10.0/24 subnet only has 10 free addresses. What should the
administrator do to enable IMC to manage Switch 2 through Switch 20?
What is the probable cause of the error message when th…
Refer to the exhibit.
A network administrator is managing the configuration files on an HP Provision switch and executes the
commands shown in the exhibit. What is the probable cause of the error message when the administrator tries
to copy the file?
What should the administrator do to prepare to upload t…
Refer to the exhibit.
A network administrator needs to upload a software image of 21,240 KBs to an HP Comware switch. The
administrator checks the flash and sees the output in Exhibit 1. The administrator then deletes the
a5800_5820x-cmw520-r1211p09.bin file. The administrator checks the flash again and sees the output in
Exhibit 2.
What should the administrator do to prepare to upload the new software image?
What should the administrator do to accomplish this?
A network administrator has copied new software to the secondary slot on an HP Provision switch. The
administrator wants to schedule a boot to the new software in two hours. What should the administrator do to
accomplish this?
Which command should the administrator use to verify th…
A network administrator copies new software to the secondary slot on an HP Provision switch and attempts to
configure the switch to boot with the secondary software. Which command should the administrator use to
verify that the appropriate changes were made?