Which activities can be performed if the Volume Manager configuration has been backed
up? (Choose three.)

What are the advantages of a concatenated volume layout? (Choose three.)

Which command can be used to refresh the information about the disks?

The datadg disk group contains four disks. A 100 MB volume named test is striped across
two disks with a stripe unit size of 4K. The following vxtrace output was generated:
START write vdev test block 115392 len 64 concurrency 1 pid 6948
3602 START write disk c1t8d0s2 op 3601 block 57696 len 8
3603 START write disk c1t9d0s2 op 3601 block 57696 len 8
3604 START write disk c1t8d0s2 op 3601 block 57704 len 8
3605 START write disk c1t9d0s2 op 3601 block 57704 len 8
3606 START write disk c1t8d0s2 op 3601 block 57712 len 8
3607 START write disk c1t9d0s2 op 3601 block 57712 len 8
3608 START write disk c1t8d0s2 op 3601 block 57720 len 8
3609 START write disk c1t9d0s2 op 3601 block 57720 len 8
3602 END write disk c1t8d0s2 op 3601 block 57696 len 8 time 0
3603 END write disk c1t9d0s2 op 3601 block 57696 len 8 time 0
3604 END write disk c1t8d0s2 op 3601 block 57704 len 8 time 1
3606 END write disk c1t8d0s2 op 3601 block 57712 len 8 time 1 3608
END write disk c1t8d0s2 op 3601 block 57720 len 8 time 1 3605
END write disk c1t9d0s2 op 3601 block 57704 len 8 time 1 3607
END write disk c1t9d0s2 op 3601 block 57712 len 8 time 1 3609
END write disk c1t9d0s2 op 3601 block 57720 len 8 time 1 3601
END write vdev test op 3601 block 115392 len 64 time 1
Assume one block is equivalent to 512 bytes. (Solaris-style disk names are not relevant.)
How many writes did Volume Manager perform to each disk?

What is the daemon that monitors changes to the Volume Manager configuration?

Which two commands start a DISABLED or DETACHED volume? (Choose two.)

Which command removes the datavol volume from the datadg disk group?

Plexes in a two-way mirror are out of sync. Data in one plex are stale while the other are
clean. Which type of resynchronization will be carried out to recover the volume?

Several disks were physically disconnected during boot up, causing several failed disks in
Volume Manager. The disks were reconnected and the operating system recognizes the
disks without a reboot. Which command can be used to fix the failed disks in Volume
Manager?

Which menu sequence in VEA executes disk setup commands appropriate for the operating
system and ensures that Volume Manager recognizes newly attached disks?