A new system administrator tries to determine the IPv6 IPMP configuration and sees the following:

# grep failover /etc/hostname6*
/etc/hostname6.hme0: -failover group mgrp6
/etc/hostname6.qfe0: -failover group mgrp6-1
/etc/hostname6.qfe1: -failover group mgrp6-1

Which statement is true?

You have a requirement to configure two new network ranges. One of these networks requires 200 IP addresses and the other requires 600 IP addresses. Which network should you use to obtain the most efficient usage of IP address space?

You have installed a Solaris OS system with two physical network interfaces in addition to the loopback interface. You have not manually modified the IP forwarding properties in any way. Which two statements regarding IP forwarding between the two interfaces are true? (Choose two.)

For which three types of IP traffic are Internet Control Message Protocol (ICMP) packets used? (Choose three.)

A Solaris system has an existing hme0 interface configured with an IPv4 address.

hme0: flags=1004843<UP,BROADCAST,RUNNING,IPv4> mtu 1500 index 2 inet 129.147.12.179 netmask ffffff00 broadcast 129.147.12.255 ether 8:0:20:f5:d7:d7

An administrator wants to test an implementation of IPv6 on this system.

Which two commands can the administrator use to add an IPv6 address to hme0? (Choose two.)

The TCP protocol has an algorithm that implements flow control on both the sender side and the receiver side. What is the function of the congestion window on the sending side?

Your workstation is suddenly unable to communicate with hosts on other subnets However, you can still ping hosts on the same network. No changes have been made to the workstation and it has not been rebooted.

The routing table on the workstation contains:

Routing Table: IPv4
Destination Gateway Flags Ref Use Interface
——————– —————— —– —– ——— ————-
129.147.12.0 129.147.12.179 U 1 3 hme0
224.0.0.0 129.147.12.179 U 1 0 hme0
127.0.0.1 127.0.0.1 UH 23 2304 lo0

What is a possible cause of this problem?

An unauthorized administrator has recently made some changes to and rebooted your server. As a result, the server is using ARP to attempt to reach hosts on a different subnetwork. Which file has been erroneously modified?

Given:

hme0: flags=2000841<UP,RUNNING,MULTICAST,IPv6> mtu 1500 index 2 inet6 fe80::a00:20ff:fef5:d7d7/10 ether 8:0:20:f5:d7:d7

Which two statements are true about this interface? (Choose two.)

You need to temporarily change the IP address on the hme0 interface on a system. Which command modifies the address to 192.168.20.118 with a broadcast address of 192.168.20.127 and a netmask of 255.255.255.192?