You are trying to upgrade an existing 1Gb/s FC SAN that is using 62.5 micron multi-mode cable
from a tape library to a server that is 175 meters away to 2Gb/s Fibre Channel. After switching to
the 2Gb/s Fibre Channel equipment, a connection to the server cannot be maintained. When a
connection is made, numerous errors are reported. What is the cause of the errors?

A customer’s database environment includes remote synchronous mirroring across a DWDM link.
Which two (2) business management requirements will be met by the implementation? (Choose
two.)

You are looking at a Fibre Channel trace log and you notice that the class 2 communication
session between one initiator and target continually stops and then restarts. You suspect that
there is a flow control problem between this pair of devices. Which login communication session
would you analyze in the trace log for the number of flow control credits that have been allocated?

There are two datacenters separated by twelve (12) km with IP connections linking the two sites.
Site A is the primary production site, Site B is for test/development & disaster recovery. Site A
synchronously replicates data to Site B for disaster recovery purposes via a merged SAN fabric
between the two sites. The communication between the two sites is lost. What storage event will
occur as a result of this?

You have just completed installing, cabling, zoning, and device masking for a new server. HBA
configuration was successful, yet the host cannot see the storage after executing a device find
command. Investigation at the switch reveals that the host is not “seen” at the switch port. Light is
visible at either end of the fiber but no link light is seen on the switch. What is the most likely cause
of the problem?

You have been asked to add 2 new PCI-X cards into an existing server architecture and notice

that they run at different clock speeds. The system has both shared and dedicated PCI bus slots
available. In order to maximize performance, which PCI cards should be installed in which slots?
(Choose two.)

You have been asked to review your fabric management plan for effectiveness and efficiency,
and to ensure that you are meeting its stated requirement. What should you check to see if you
are meeting the defined SLAs?

A Fibre Channel switch failed in your fabric and a replacement switch has been delivered. Which
two (2) actions should be taken before plugging the replacement switch into the fabric? (Choose
two.)

Click the Exhibit button.

Servers in your environment are connected to one physical infrastructure which consists of
different logical fabrics. Which feature do you use to implement this topology?

A customer has deployed redundant switched fabrics in a HA environment which also includes

non-HA, single-attached test servers. A new project requires additional connectivity for new HA
servers to be placed into production, but there are not enough free ports available in one of the
existing fabrics to complete the HA deployment. Which option would allow for the addition of the
new hosts while maintaining the redundant infrastructure at least cost?