Refer to the exhibit.

A connection times out when Client41 and Client42 attempt to either establish an HTTP session to Server31 or
an FTP connection to Server32 after not connecting to them for some time. The very next attempt to connect to
these services done immediately after the failure seems to work correctly. The clients are able to ping both
servers and no access-lists are configured on the routers. SH3 uses the IP address of R3f0 as its default
gateway. Upon powering off SH3 and SH4, the problem goes away even for first connection and everything
works normally (even after not connecting for extended periods of time). Which of the following are likely to
correct this problem?

Refer to the exhibit.

SH3 and SH4 are able to optimize HTTP sessions from Client41 to application host Server31. However,
Client41 receives a failure messagE. “ftp connect: Unknown error number” while trying to connect Server32.
The same applies to Client42. Note that SH3 and SH4 are in auto-discovery mode. Client41 and Client42 are
able to ping Server32. What is the most likely cause of this failure?

Refer to the exhibit.

SH3 and SH4 are able to optimize FTP and HTTP sessions between Client41 and the respective application
hosts Server31 and Server32. However, optimization seems to be a problem for Client42 and these application
hosts. A quick check on SH3 and SH4 registers neither optimized nor pass-through traffic from Client42.
Client42 is able to ping to both Server31 and Server32. Note that SH3 and SH4 are in auto-discovery mode.
What is the likely cause?

Refer to the exhibit.

In the accompanying exhibit, SH3 and SH4 are able to optimize FTP and HTTP sessions between Client41 and
the respective application hosts Server31 and Server32. However, optimization does not happen for Client42
and these application hosts. A quick check on SH3 and SH4 registers neither optimized nor pass-through traffic
from Client42. Client42 is able to ping Client41 and the in-path address of SH4. Note that SH3 and SH4 are in
auto-discovery mode. What is the likely cause?

What should you do when you receive the following message?
[intercept.NOTICE] sending kickoff RST: 10.35.178.41:1169 -> 10.110.141.30:1031.

What should you do when you receive the following message?

When troubleshooting a datastore wrapping alarm with 1 day wrapping notification configured, which of the
following should be examined? (Select 2)

In a new physical in-path deployment, you realize that a Steelhead appliance at one of your branch offices is
optimizing connections from other sites, however, no connections initiated from that branch office are being
optimized. Which of the following is the most likely cause of this problem?

You need to perform a tcpdump of traffic entering the Steelhead appliance’s lan0_0 interface. Which of the
following demonstrate the proper command format to perform the tcpdump and capture to a file?

A customer with a new physical in-path installation decides to turn on the optimization service during lunch time
on a working day. This is done so that he can see if the users perceive any performance improvement. When
starting the optimization service, he does not enable the in-path kickoff option. Assuming there were several
already active connections when he starts the optimization service, how will the Steelhead appliances handle
these existing connections?