Select the command needed to add support for virtual in-path to your Steelhead appliance so that you can use
WCCP or PBR with a Steelhead appliance.

How can you enable SkipWare?

Refer to the exhibit.

The customer would like to prevent a “black-holing” situation when using PBR when SH11 goes down. The
Steelhead appliances are directly connected to the routers. What options are available to determine state level
status of the Steelhead appliance? (Select 3)

In the exhibit,

which interfaces should the WCCP router R1 listen to for multicast communication with the server-side
Steelhead appliances, assuming the multicast address is 239.0.0.1? (Select 2)

In the exhibit,

where should the WCCP redirection take place for server return traffic, assuming redirect IN is used? (Select 2)

In the exhibit,

where should the WCCP redirection take place for traffic originating from the clients to the servers, assuming
redirect IN is used?

Refer to the exhibit.

Assume that a packet being optimized by SH10 incorrectly ends up on SH11 (due to load balancing error, or
similar). How can you ensure that this packet is correctly returned to SH10?

Which of the following points on WCCP v2 are correct? (Select 4)

Which of the following control messages are NOT used by WCCP? (Select 2)

When enabling WCCP v2 support, what does a multicast TTL value of 1 imply?