You are asked to install a 6-node cluster of FAS8080 controllers. The installation has been completed and Config Advisor shows no warnings or errors. The
customer can ping and access the controller.
Which statement is true in this scenario?

A.
This installation has not been completed successfully until you have confirmed that SSH is enabled.

B.
This installation has not been completed successfully until the customer and NetApp Support have received a minimum of three AutoSupport messages.

C.
This installation has been completed successfully only if you have confirmed that the configuration is correct.

D.
This installation has been completed successfully, because Config Advisor would identify the missing configuration.

Explanation:
Config Advisor is a configuration validation and health check tool. It is used to check for common configuration errors. You can use the Config Advisor tool to verify
that the cluster is cabled correctly. After Config Advisor indicates that no errors is found, you must complete protocol configuration and verify cluster setup.
Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems, page 33