A customer has replaced both interconnect cables on a FAS3240 HA pair with IOXM because they were
damaged. After replacing the cables, the customer receives the error shown below.
“HA interconnect port 1 of this appliance seems to be connected to port 2 on the partner appliance.”
In this scenario what is the cause of this error?

A.
The interconnect cables must not be replaced while the controllers are up and running.

B.
c0a and c0b are 10Gbit Ethernet ports which must not be used for the interconnect.

C.
The interconnects are cross-cabled, you must connect c0a with c0a and c0b with c0b.

D.
You must issue the if config down. . . command followed by the if config up … command for both ports,
on both controllers, after replacing the cables.