Note: This question is part of a series of questions that use the same or similar answer choices. An answer
choice may be correct for more than one question in the series. Each question is independent of the other
questions in this series. Information and details provided in a question apply only to that question.
You have a DHCP server named Server1 that has three network cards. Each network card is configured to use
a static IP address.
You need to prevent all client computers that have physical address beginning with 98-5F from leasing an IP
address from Server1.
What should you do?
A.
From the properties of Scope1, modify the Conflict detection attempts setting.
B.
From the properties of Scope1, configure Name Protection.
C.
From the properties of IPv4, configure the bindings.
D.
From IPv4, create a new filter.
E.
From the properties of Scope1, create an exclusion range.
F.
From IPv4, run the DHCP Policy Configuration Wizard.
G.
From Control Panel, modify the properties of Ethernet.
H.
From Scope1, create a reservation.
Explanation:
https://technet.microsoft.com/en-us/library/ee941125(v=ws.10).aspx
Right answer:
D.From IPv4, create a new filter.
Explanation:
https://technet.microsoft.com/en-us/library/dd759190(v=ws.11).aspx
22
2
Correct – D.From IPv4, create a new filter
https://www.windows-server-2012-r2.com/dhcp-filter-in-windows-server-2012-r.html
7
0
https://technet.microsoft.com/en-us/library/dn425039(v=ws.11).aspx
It is a DHCP policy – went to test lab to determine answer…
0
3
It might even be the answer F – From IPv4, run the DHCP Policy Configuration Wizard because it allows you to block MAC addresses, but to create a DHCP policy is within scope, so I believe the answer is wrong.
The correct answer would be “D – From IPv4, create a new filter.”
3
0
Filter will control allowed MAC addresses
2
0
Filter will block individual MAC address. Policy will allow a wildcard.
3
1
I disagree. The only good answer is D. You can block MAC with wildcard
4
0
More new 70-741 Questions: https://drive.google.com/drive/folders/0B75b5xYLjSSNSUt4dmtFZ2pDQkk?usp=sharing
1
0
The right awnser is D “From IPv4, create a new filter.”
right-click over “Deny” and create New Filter
IPv4–>Filters–>Deny
On MAC address field put 98-5F-* and press Add
14
0
Hi, Messias,
God sent you to this chaos. Finally someone who has right answers.
Keep it up!
1
0
For all addresses beginning with 98-5F plz create a new filter from IPv4
1
0