Your network contains a server named Server1 that has the Network Policy and Access
Services server role installed.
All of the network access servers forward connection requests to Server1.
You create a new network policy on Server1.
You need to ensure that the new policy applies only to connection requests from the
192.168.0.0/24 subnet.
What should you do?
A.
Set the Client IP4 Address condition to 192.168.0.0/24.
B.
Set the Client IP4 Address condition to 192.168.0.
C.
Set the Called Station ID constraint to 192.168.0.0/24.
D.
Set the Called Station ID constraint to 192.168.0.
Explanation:
RADIUS client properties
Following are the RADIUS client conditions that you can configure in network policy.
• Calling Station ID: Specifies the network access server telephone number that was
dialed by the dial-up access client.
• Client Friendly Name: Specifies the name of the RADIUS client that forwarded the
connection request to the NPS server.
• Client IPv4 Address: Specifies the Internet Protocol (IP) version 4 address of the
RADIUS client that forwarded the connection request to the NPS server.
• Client IPv6 Address: Specifies the Internet Protocol (IP) version 6 address of the
RADIUS client that forwarded the connection request to the NPS server.
• Client Vendor: Specifies the name of the vendor or manufacturer of the RADIUS
client that sends connection requests to the NPS server.
• MS RAS Vendor: Specifies the vendor identification number of the network access
server that is requesting authentication.