Your network contains two subnets. The subnets are configured as shown in the following
table.
You have a server named Server1 that runs Windows Server 2012 R2. Server1 is connected
to LAN1.
You run the route print command as shown in the exhibit. (Click the Exhibit button.)
You need to ensure that Server1 can communicate with the client computers on LAN2.
What should you do?
A.
Change the default gateway address.
B.
Set the state of the Microsoft ISATAP Adapter #2 interface to disable.
C.
Change the metric of the 10.10.1.0 route.
D.
Set the state of the Teredo interface to disable.
Explanation:
The exhibit shows the default gateway address to be that of LAN1. This should be changed
to the LAN2 gateway address to allow client computers access on LAN2.
References:
Training Guide: Installing and Configuring Windows Server 2012 R2, Chapter 4: Deploying
domain controllers, Lesson 4: Configuring IPv6/IPv4 Interoperability, p. 254-256