HOTSPOT
You have a Hyper-V host named Hyperv1 that runs Windows Server 2012 R2. Hyperv1 hosts a virtual
machine named Server1. Server1 uses a disk named Server1.vhdx that is stored locally on Hyperv1.
You stop Server1, and then you move Server1.vhdx to an iSCSI target that is located on another
server.
You need to configure Server1 to meet the following requirements:
Ensure that Server1 can start by using Server1.vhdx.
Prevent Server1.vhdx from consuming more than 500 IOPS on the iSCSI target.
Which two objects should you configure?
To answer, select the appropriate two objects in the answer area.
Answer: 
1)Select Firmware for the boot device selection this is assuming the disk has already been attached
2)select advanced under the hard disk
0
0
The info mentioned in the post are a few of the best out there
0
0
here are some hyperlinks to sites that we link to mainly because we assume they may be worth visiting
0
0
one of our guests lately proposed the following website
0
0
just beneath, are many completely not related websites to ours, even so, they’re certainly worth going over
0
0
please visit the web sites we stick to, like this one particular, as it represents our picks in the web
0
0
Howdy I am so happy I found your web site, I really found you by accident, while I was searching on Yahoo for something else, Anyways I am here now and would just like to say thanks a lot for a fantastic post and a all round entertaining blog (I also love the theme/design), I don’t have time to read it all at the minute but I have saved it and also added in your RSS feeds, so when I have time I will be back to read much more, Please do keep up the fantastic job.
https://www.youtube.com/watch?v=MQc9pbcSAQQ
0
0