You have a server named Server1 that runs Windows Server 2012 R2.
On Server1, you open Computer Management as shown in the exhibit. (Click the Exhibit button.)

You need to ensure that you can create a 3-TB volume on Disk 1.
What should you do?

You have a Hyper-V host named Server1 that runs Windows Server 2012 R2.
Server1 hosts a virtual machine named VM1 that runs Windows Server 2012 R2.
VM1 has several snapshots.
You need to modify the snapshot file location of VM1.
What should you do?

HOTSPOT
You have a Hyper-V host named HYPERV1. HYPERV1 hosts a virtual machine named DC1.
You need to prevent the clock on DC1 from synchronizing from the clock on HYPERV1.
What should you configure? To answer, select the appropriate object in the answer area.
Hot Area:

Your network contains a Hyper-V host named Server1 that runs Windows Server 2012 R2.
Server1 hosts a virtual machine named VM1 that runs Windows Server 2012 R2.
You create a checkpoint of VM1, and then you install an application on VM1. You verify that the application runs
properly.
You need to ensure that the current state of VM1 is contained in a single virtual hard disk file.
The solution must minimize the amount of downtime on VM1.
What should you do?

HOTSPOT
Your network contains an Active Directory domain named contoso.com.
Technicians use Windows Deployment Services {WDS) to deploy Windows Server 2012 R2.
The network contains a server named Server1 that runs Windows Server 2012 R2. Server1 has the Hyper-V
server role installed.
You need to ensure that you can use WDS to deploy Windows Server 2012 R2 to a virtual machine named
VM1.Which settings should you configure?
To answer, select the appropriate settings in the answer area.
Hot Area:

Your network contains an Active Directory domain named adatum.com. The domain contains a member server
named Host1. Host1 runs Windows Server 2012 R2 and has the Hyper-V server role installed.
Host1 hosts two virtual machines named VM5 and VM6. Both virtual machines connect to a virtual switch
named Virtual1.
On VM5, you install a network monitoring application named Monitor1.
You need to capture all of the inbound and outbound traffic to VM6 by using Monitor1.
Which two commands should you run from Windows PowerShell? (Each correct answer presents part of the
solution. Choose two.)

You have a server named Server1 that runs Windows Server 2012 R2. Server1 has the Hyper-V server role
installed. On Server1, you create a virtual machine named VM1.
VM1 has a legacy network adapter.
You need to assign a specific amount of available network bandwidth to VM1.
What should you do first?

You have a server named Server1 that runs Windows Server 2012 R2. Server1 has the Hyper-V server role
installed.
The disks on Server1 are configured as shown in the exhibit. (Click the Exhibit button.)

You create a virtual machine on Server1.
You need to ensure that you can configure a pass-through disk for the virtual machine.
What should you do?

Your network contains an Active Directory domain named contoso.com. The domain contains a server named
Server 1. Server1 runs Windows Server 2012 R2.
You need to create a 3-TB virtual hard disk (VHD) on Server1.
Which tool should you use?

Your company deploys a new Active Directory forest named contoso.com. The first domain controller in theforest runs Windows Server 2012 R2. The forest contains a domain controller named DC10.
On DC10, the disk that contains the SYSVOL folder fails.
You replace the failed disk. You stop the Distributed File System (DFS) Replication service. You restore the
SYSVOL folder.
You need to perform a non-authoritative synchronization of SYSVOL on DC10.
Which tool should you use before you start the DFS Replication service on DC10?