Which RAID level provides most redundancy?
Which RAID level provides most redundancy?
Which of the following actions is the best one to be used in order to identify and fix the problem?
The Linux kernel is loaded successfully by the boot loader. However, straight after the kernel mounts the root filesystem, the boot process stops and an error message regarding init is shown. Which of the following actions is the best one to be used in order to identify and fix the problem?
What command must be used to create an ext3 filesystem?
What command must be used to create an ext3 filesystem?
which device is used to represent the CD writer?
A system has one hard disk, configured as master and connected to the primary IDE controller, and one CD writer, configured as slave and connected to the secondary IDE controller. If the system is correctly configured, which device is used to represent the CD writer?
How can this be done?
A new PCMCIA network card is not functioning correctly. To troubleshoot this, the socket information should be checked. How can this be done? (Choose two.)
which of the following directories?
If the path parameter is not set for a share in the smb.conf file, the share will refer to which of the following directories?
Which of the following configuration lines will export /usr/local/share/ to nfsclient with read-write access&#
Which of the following configuration lines will export /usr/local/share/ to nfsclient with read-write access, ensuring that all changes are straight to the disk?
Where else could be this different runlevel be defined?
After changing the default runlevel in the init configuration file, the system boots in a different than the intended runlevel. Where else could be this different runlevel be defined?
What command must be run to make all of the other file-systems listed in /etc/fstab accessible?
A machine is running in single user mode and, as such, not all file-systems are accessible. What command must be run to make all of the other file-systems listed in /etc/fstab accessible?
What command can be used to check the Samba configuration file?
What command can be used to check the Samba configuration file?