What file should the path to the libraries be added to, before running ldconfig?
You have installed some new libraries, but these are not available to programs and are not listed by
lconfig –p. What file should the path to the libraries be added to, before running ldconfig?
which file in the/boot directory contains the kernel configuration parameters?
On a server running the 2.6.27-11 Linux kernel, which file in the/boot directory contains the kernel configuration
parameters?
Which chkconfig command will display whether or not the service ldap is configured to start in each runlevel?
Which chkconfig command will display whether or not the service ldap is configured to start in each runlevel?
(Provide the command and any options or parameters)
what is the command, with options or parameters, to make named re-read its zone files?
Using only commands included with named, what is the command, with options or parameters, to make named re-read its
zone files?
How is it possible to ensure that the card using the 8139too driver is detected before the card using the ne2k
The server has two network cards. The driver for the first card is the module 8139too and the driver for the second card is the module ne2k-pci. How is it possible to ensure that the card using the 8139too driver is detected before the card using the ne2k-pci driver?
Which of the following is needed, to synchronise the UNIX password with the SMB password,
Which of the following is needed, to synchronise the UNIX password with the SMB password, when the encrypted SMB password in the smbpasswd file is changed?
Which of the following commands should be used in a bash script that needs a variable containing the IP addres
Which of the following commands should be used in a bash script that needs a variable containing the IP address of
the eth0 interface? The output for the command ifconfig eth0 is shown below:
eth0 Link encap:Ethernet HWaddr 00:0C:29:CB:FA:30
inet addr:192.168.246.11 Bcast:192.168.246.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4721 errors:0 dropped:0 overruns:0 frame:0 TX packets:3216 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:445184 (434.7 Kb) TX bytes:512968 (500.9 Kb) Interrupt:185 Base address:0x1080
Which of the following entries are NOT valid in /etc/raidtab?
Which of the following entries are NOT valid in /etc/raidtab?
How to remove the patch patch-2.4.28.tar.bz2 from a kernel source tree?
To remove the patch patch-2.4.28.tar.bz2 from a kernel source tree, the command that must be used is:
Which RAID level provides the most redundancy?
Which RAID level provides the most redundancy?