You are monitoring the control plane traffic using a network analyzer on an Ethernet network
segment with all routers configured with IS-IS routing. Which two statements are true? (Choose
two.)

Click the Exhibit button.

In the exhibit, Customer A uses private RFC1918 addresses within its network. The customer
wants to have all Internet access for its organization transit through the main office for security and
NAT purposes. Each of the PE routers in your network contains Internet routes in the main
instance routing table and is capable of provisioning both a VRF and a non-VRF interface to its
attached CE router. Which router should be configured to accomplish the administrative goal of
the customer?

Click the Exhibit button.

Customer A is complaining that routes advertised from the CE2 router are not being received on
the CE1 router. The physical topology of the network is CE1-PE1-PE2-CE2. The CE1-PE1 subnet
is 172.16.1.0/24. The CE2-PE2 subnet is 172.16.2.0/24. PE1’s loopback is 192.168.3.1 and PE2’s
loopback is 192.168.4.1.Referring to the output in the exhibit, what is the problem?

Click the Exhibit button.

In the exhibit, all routers within each AS are configured for Anycast RP. All intra-AS routers are
configured within the same MSDP mesh group. Inter-AS multicast has been enabled using MSDP
without MSDP mesh groups. Which statement is true?

Click the Exhibit button.

On your MX Series router, traffic using the less-critical scheduler is out of profile. All other data is
currently in profile. Referring to the exhibit, which statement is correct?

Click the Exhibit button.

Traffic is flowing through the policer as shown in the exhibit. The traffic has a throughput rate of 3
Mbps, and the burst size counter is at 1.5 MB. How is traffic affected?

Which two configuration parameters are required to configure an LDP-signaled VPLS service?
(Choose two.)

Click the Exhibit button.

As shown in the exhibit, you have an LSP established from R1 to R4. Your network experiences a
link failure between R2 and R3.Which statement is correct?

Click the Exhibit button.

What is the significance of RIB groups, as shown in the exhibit?

Click the Exhibit button.

After adding Customer C to your Layer 3 VPN, you must validate that PE2 is receiving VPN routes
for all customers attached to PE1, as shown in the exhibit. Which operational command displays
this information?