What is causing the interchassis communication issues?
Two High End SRX Series devices are configured in a chassis cluster, but interchassis communication is problematic and intermittent. Node 0 has SPCs located in slots 1, 2, 5, and 10 and has IOCs located in slots 3 and A. Node 1 has SPCs located in slots 13.14,18, and 22 and has IOCs located in slots 15 and 16.
What is causing the interchassis communication issues?
Which two scans should you be concerned about?
You want to limit attacks on TCP ports.
Which two scans should you be concerned about? (Choose two)
Which two parameters must be configured for your application to work properly?
You have a VoIP application that requires external sessions to be initiated into your environment. Your network only has a single public IP address configured on the egress interface.
Which two parameters must be configured for your application to work properly? (Choose two)
Which NAT configuration will correct the problem?
Your new employer has contacted you because the company’s Web servers located at the DM2 (dmz zone) are not reachable from the Internet (untrust zone). After examining the configuration from the previous administrator, you determine that the problem must be with the NAT configuration. The servers have the internal IP addresses 172.14 14 9/24 and 172.14.14 10/24.
Which NAT configuration will correct the problem?
Which two protection mechanisms are supported on SRX Series Services Gateways?
Which two protection mechanisms are supported on SRX Series Services Gateways? (Choose two)
Which configuration parameter meets this requirement?
You want to implement an IPS rule base action in which matching traffic is dropped.
Which configuration parameter meets this requirement?
What are two primary requirements?
You have been asked to add a dynamic VPN to your SRX650. This dynamic VPN must be able to support five users at the same time.
What are two primary requirements? (Choose two.)
Which two actions are required to do this?
You have a problem with an FTP session that will not establish through your SRX240 device. You confirmed that routing and security policies are correct. You want to capture packets to further troubleshoot the problem.
Which two actions are required to do this? (Choose two.)
What else must you do to make the remote networks reachable?
You are configuring a hub-and-spoke VPN topology between an SRX Series device deployed at the hub site and several non-Juniper devices at spoke sites. You have decided to use static routes on the hub device to make the spoke network reachable.
What else must you do to make the remote networks reachable?
how does the IPS engine inspect the traffic?
In terms of application and protocol recognition, how does the IPS engine inspect the traffic?