You enter the following command
set int e8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.248 How many MIP address translations have you just configured?

Which two (2) methods can be sued to verify that NAT-src translation has occurred?

Place the configuration steps for NAT-dst in the recommended order:
1) configure policy
2) configure route or secondary address on internal interface
3) configure address book entry for public address

Which form of NAT performs bi-directional translation?

What is a DIP IP shift?

You have one VIP configured on your device, using public address 191.111.222.5. When you configure the policy, what will you select for the VIP, and where will you select it?

You have a host that is assigned an IP from private address space that needs to access public addresses on the internet. AT the same time, a system from the public network needs to access the services of that system. You have plenty of public addresses available for use. Which type of NAT would you use?

On a 5GT using multi-cell policies, what is the largest number of entries that can be entered into the source, destination or service fields?

What will result in the largest number of policies being counted against the total policies allowed for the NetScreen device?

What should be done if you needed to create a policy to control DNS zone transfers, but allows basic DNS queries to go through?