What would be the best routing command to allow host Certkiller A to communicate with host Certkiller B?
Exhibit
Review the exhibit. What would be the best routing command to allow host Certkiller A to communicate with host Certkiller B? (Assume a route from the 208 to Host Certkiller A’s subnet already exists.)
Which interface would be used to forward traffic to host 1.1.7.5?
Exhibit
Review the exhibit. Which interface would be used to forward traffic to host 1.1.7.5?
when will inspection be performed?
When adding Deep Inspection to policy, when will inspection be performed?(Exhibit)
Which policy action is needed in order to add Deep Packet inspection to a policy?
Which policy action is needed in order to add Deep Packet inspection to a policy?(Exhibit)
What gateway address will you configure on the 5XT for the VPN?
Exhibit
Refer to the exhibit. You need to make a bi-directional VPN between the 5XT and the 208. What gateway address will you configure on the 5XT for the VPN?
where are policies going to be required?
Exhibit
Review the exhibit. In this route-based VPN configuration, where are policies going to be required?
where are changes stored when a “save” command is issued from the CLI during a management sessions
By default, where are changes stored when a "save" command is issued from the CLI during a management sessions?(Exhibit)
which sequence of steps must be performed to make the interface operational at the end of the configuration se
When configuring theUntrustinterface with an IP address and enabling Telnet andWebUI management, which sequence of steps must be performed to make the interface operational at the end of the configuration sequence?(Exhibit)
what external hardware component can the changes be saved?
When changes are made to the running config during aWebUImanagement session, to what external hardware component can the changes be saved?(Exhibit)
What two things can cause this occur?
You have created a route-based VPN. When you try to connect to the remote device you see the following message in your event log:
No policy exists for the proxy id received
What two (2) things can cause this occur?