Click the Exhibit button. In the exhibit, all routers are sending routes to Router B. Which
routes will be advertised from Router B to Router E?

In your RSVP network you have configured three separate LSPs to the same egress
address. You have made no other configuration changes to the forwarding decisions made
by the router. Which commands can you use to determine which LSP is being used to
forward packets?

Which two values are used by an RSTP bridge to remove stale BPDU information? (Choose
two.)

Click the Exhibit button. After the MAC learning limit of 3000 is reached for the bd bridge
domain as shown in the exhibit, what happens to frames that arrive that contain unknown
unicast destination addresses?

You have recently configured MSTP on two switches in your network to participate in the
same MSTP region. You issue the show spanning-tree mstp configuration command on
both switches and notice that the configuration digests do not match. What does this
mismatch indicate?

You have a stub OSPF area running in your network. Your supervisor has asked you to
build a virtual link across this area to connect new equipment acquired in a recent ISP
acquisition. Which statement is correct about this scenario?

You own a small company and need to assign IPv6 addresses to your routers. Because you
want to follow the guidelines spelled out in RFC 3177, you want to design your network with
the correct prefixes. Which prefix would your ISP likely allocate to your company?

Your customer would like to forward traffic using DLCI 600 and maintain Layer 2 information
across a VPN. Which solution will meet these requirements?

You have two OSPF routers that are trying to form an adjacency. When you issue the
command show ospf neighbor, you see that one router is in the loading state and the other
is in the full state. Why are you seeing the router’s state as loading?

Which two events could cause the BGP Active state to appear? (Choose two.)