You want to configure support for an IPv6 environment In which hierarchy would you configure an OSPF area?
You want to configure support for an IPv6 environment In which hierarchy would you configure an OSPF area?
Which action does the local router take after sending a Notification message to a remote peer?
Which action does the local router take after sending a Notification message to a remote peer?
Which method of address assignment would accomplish these requirements?
You have been asked to configure and assign addresses for your IPv6 routers in your network using dynamic assignment of DNS servers. You do not want the MAC address included as part of the IPv6 address.
Which method of address assignment would accomplish these requirements?
Which two topologies shown in the exhibit would require the use of a spanning-tree protocol? (Choose two)
Refer to the Exhibit
Which two topologies shown in the exhibit would require the use of a spanning-tree protocol? (Choose two)
Which three functions are performed by an OSPF area border router (ABR)? (Choose three)
Which three functions are performed by an OSPF area border router (ABR)? (Choose three)
Which configuration will allow for the switch to potentially look at the IP header of incoming frames tagged w
A customer configures a bridge domain using a VLAN ID of 222.
Which configuration will allow for the switch to potentially look at the IP header of incoming frames tagged with a VLAN ID of 222?
What would the ABR do with the information learned from the non-backbone area?
Your area border router (ABR) receives type 1.2 and 5 link-state advertisements (LSAs) from a non-backbone area.
What would the ABR do with the information learned from the non-backbone area?
Which label operation is performed by an MPLS ingress router?
Which label operation is performed by an MPLS ingress router?
Which operational mode command will help you verify your suspicions?
An RSVP LSP in your network is operational but you are receiving complaints about network throughput across the LSP. You suspect that the RSVP bandwidth was omitted from the router configuration.
Which operational mode command will help you verify your suspicions?
What are two reasons that would cause this situation? (Choose two)
After configuring OSPF between two routers you check for an adjacency. You see that the adjacencies are not coming up on an Ethernet segment.
What are two reasons that would cause this situation? (Choose two)