What are three types of NAT that Juniper Networks routers support?
What are three types of NAT that Juniper Networks routers support? (Choose three.)
What must you do to avoid routing loops?
You are using the route redistribution strategy to transition your network from RIP to OSPF. What must you do to avoid routing loops?
Which two attributes should be used for this?
BGP communities can be used to influence your ingress traffic from the Internet. The communities signal the ISP to change specific route attributes for this purpose. Which two attributes should be used for this? (Choose two.)
Which state indicates that the router is using an application-layer gateway (ALG) to forward traffic?
You are examining the output of the stateful firewall session table. Which state indicates that the router is using an application-layer gateway (ALG) to forward traffic?
Which two commands would show you this information?
You want to verify that traffic is being classified correctly and forwarded in the proper queue on interface fe-0/0/1. Which two commands would show you this information? (Choose two.)
Which statement is true?
Which statement is true?
What are two useful actions?
You are troubleshooting a CoS problem for packets transitioning the router. What are two useful actions? (Choose two.)
Which command will allow you to monitor the fan status on a router?
Which command will allow you to monitor the fan status on a router?
Which single command would you use to identify all protocols running on a router?
Which single command would you use to identify all protocols running on a router?
You found a log message from your router as follows:Aug 9 19:16:51 radon-re0 chassisd[2622]: CHASSISD_FRU_EVEN
You found a log message from your router as follows:
Aug 9 19:16:51 radon-re0 chassisd[2622]: CHASSISD_FRU_EVENT:
scb_recv_slot_attach: attached FPC 0
Which part of the message code indicates the process that generated the message?