Your network has multiple BGP connections to your ISP’s edge router. You are asked to influence
which router is used by traffic entering your network without asking the ISP to make changes in
their network.
Which attribute should be used?

Your network has multiple BGP connections to your ISP’s edge router. You are asked to influence
which router is used by traffic entering your network without asking the ISP to make changes in
their network.
Which attribute should be used?

You have recently configured EBGP on R1 using the ge-0/0/2 interface. You notice that the
EBGP-learned routes are present on R1 but these routes are not present in the routing tables on
any of the other IBGP peers. During your investigation, you notice that the routes on the other
IBGP peers are hidden.

What are two solutions to this problem? (Choose two.)

You want to establish an EBGP peering session with the loopback IP address of your peer router.
Which BGP parameter must be used to accomplish this task?

You are advertising your network’s assigned prefixes to two upstream ISPs using BGP. You want
incoming traffic to prefer ISP-A over ISP-B.
Which action would you take to accomplish this task?

Which set of BGP attributes is preferred by the Junos OS?

Which three statements are true regarding BGP peers? (Choose three.)

What is the correct sequence of the BGP route selection process?

Your ISP reports that you are being sent a route prefix but you cannot see it in your routing table.
Which two commands will help? (Choose two.)

— Exhibit —
[edit]
user@router# commit
[edit protocols]

‘bgp’
Error in neighbor 172.27.1.4 of group ebgp:
must define local autonomous system when enabling BGP
error: configuration check-out failed
— Exhibit —
You are configuring BGP on a new router. While attempting to commit the configuration, you
receive the error shown in the exhibit.
What must be done to allow the commit to complete?