What are two BGP session types?
What are two BGP session types? (Choose two.)
Which configuration will satisfy the requirement?
You are asked to configure a port to support both tagged and untagged traffic. You want to make
the trunk port ge-0/0/0 and also accept untagged traffic for the data VLAN.
Which configuration will satisfy the requirement?
Which commands enable this?
You want to enable an Ethernet Link Aggregation Group (LAG) on an EX Series switch.
Which commands enable this?
Which statement describes a routing instance on a Junos device?
Which statement describes a routing instance on a Junos device?
Which statement is true regarding redundant trunk groups (RTGs)?
Which statement is true regarding redundant trunk groups (RTGs)?
Which command would you use to verify that the load balancing is active?
You have implemented per-packet load balancing.
Which command would you use to verify that the load balancing is active?
What is the cause of this problem?
A GRE tunnel is configured between Router1 and Router2 across the Internet. Performance on
the GRE tunnel is slow and Router1 is receiving ICMP messages from Router2.
What is the cause of this problem?
Which command will satisfy this requirement?
You would like the network attached to the ge-0/0/1.0 interface to be advertised into OSPF, but
you also want to prevent OSPF adjacencies from being formed on ge-0/0/1.0.
Which command will satisfy this requirement?
Which two steps must you perform?
You have an EX Series switch. You want to provide inter-VLAN routing between VLAN A and
VLAN B.
Which two steps must you perform? (Choose two.)
Which two put ge-0/0/0 and ge-0/0/1 into the VLAN data?
Which two put ge-0/0/0 and ge-0/0/1 into the VLAN data? (Choose two.)