Which protocol should you enable on the EX Series switch to address this condition in the future? (Choose two
A Layer 2 forwarding loop occurred on your network during a scheduled maintenance period. You must prevent this behavior in the future.
Which protocol should you enable on the EX Series switch to address this condition in the future? (Choose two.)
Referring to the exhibit and based on the output below from Sw-1 and Sw-2, which statement is true?
Refer to the Exhibit.
Referring to the exhibit and based on the output below from Sw-1 and Sw-2, which statement is true?
100/16 prefix?
Refer to the Exhibit.
In the exhibit, the 10.100/16 prefix is introduced at autonomous system 1 (AS1) and propagated through to AS3. Router A in AS3 receives two different paths to these prefixes, one through AS2 and the other through AS4. No BGP attributes have been altered.
Which path would router A prefer for the 10.100/16 prefix?
How will ISP B choose its best BGP route between ISP A and ISP C?
Refer to the Exhibit.
In the exhibit, the 67.43.142/24 route is advertised using BGP to ISPs A and C. No policies have been applied.
How will ISP B choose its best BGP route between ISP A and ISP C?
Based on the exhibit, what is preventing the adjacency?
Refer to the Exhibit.
Your company is integrating another OSPF area into your existing OSPF infrastructure. You created a virtual link that spans Area 2 and connects Area 3 to the backbone area. Based on the exhibit, what is preventing the adjacency?
Which protocol meets this requirement?
A network routes IPv4 traffic only. You want to add IPv6 to the network, but you must use a single IGP for both IPv4 and IPv6 traffic. Which protocol meets this requirement?
Based on the configuration in the exhibit, which routing table is used for IPv4 multicast RPF checks?
Refer to the Exhibit.
Based on the configuration in the exhibit, which routing table is used for IPv4 multicast RPF checks?
Referring to the exhibit, what are two requirements for an OSPF virtual link to operate correctly? (Choose two
Refer to the Exhibit.
You are asked to configure an OSPF virtual link that connects remote Area 4 to the backbone.
Referring to the exhibit, what are two requirements for an OSPF virtual link to operate correctly? (Choose two.)
Which spanning-tree approach has the least impact on control-plane performance?
You must configure your access switch with more than 3000 VLANs and you want the ability to load-balance across them. Which spanning-tree approach has the least impact on control-plane performance?
Which type of classifier is needed?
Voice traffic is coming in on UDP port 17689. This traffic must be classified into the expedited- forwarding forwarding-class. Which type of classifier is needed?