What are two benefits of configuring a ScreenOS device in transparent mode?
What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
Which ScreenOS CLI commands would be used to enable traffic logging in policy edit mode?
Which ScreenOS CLI commands would be used to enable traffic logging in policy edit mode?
Which command would you run to check IPSec Phase 1 active status?
Which command would you run to check IPSec Phase 1 active status?
What else should be configured to limit telnet access to the ScreenOS devie from trusted management PCs?
Telnet management has been enabled on an interface in the untrust zone. What else should be configured to limit telnet access to the ScreenOS devie from trusted management PCs?
What needs to be configured in Phase 2 of a route-based VPN that does not need to be configured in a policy-ba
What needs to be configured in Phase 2 of a route-based VPN that does not need to be configured in a policy-based VPN?
What are three likely reasons for the failure?
You are looking at the event log of the responding device and it says ” Rejected an initial Phase 1 packet from an unrecognized peer gateway”. What are three likely reasons for the failure? (Choose three.)
What will the firewall do?
A ScreenOS firewall is running in transparent mode. The firewall receives a packet which has no entry in its forwarding table. What will the firewall do?
Which two would cause this to occur?
You have created a route-based VPN in your ScreenOS device. When the remote device tries to connect you see the following message in your event log, “No Policy exist for the proxy id received”. Which two would cause this to occur? (Choose two.)
Which command is used to verify IKE Phase 1 is complete?
Which command is used to verify IKE Phase 1 is complete?
Which two should be verified?
Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no cookie. Which two should be verified? (Choose two.)