Referring to the exhibit, which MPLS feature was used to make the LSP the preferred path for internal routes?
Refer to the Exhibit.
Referring to the exhibit, which MPLS feature was used to make the LSP the preferred path for internal routes?
You must also summarize the loopback addresses of R1 and R2 into a single address in Area 0.Which configuratio
Refer to the Exhibit.
In the exhibit, Area 1 is a not-so-stubby area. Three networks are redistributed into Area 1 on R2. You must summarize the redistributed network addresses in Area 1 so that only one network prefix is re-advertised into Area 0. You must also summarize the loopback addresses of R1 and R2 into a single address in Area 0.Which configuration sample on R3 and R5 will complete this task?
Junos scripts can be written in which two languages? (Choose two.)
Junos scripts can be written in which two languages? (Choose two.)
What will allow you to accomplish this?
You manage an MPLS network. You are asked to classify traffic using the EXP bits from ingress to egress. What will allow you to accomplish this?
R3 should only receive one copy of all routes sent from R4.Which configuration is valid?
Refer to the Exhibit.
The routers shown in the exhibit are connected in a full BGP mesh. R1 is the route reflector and R2 through R5 are clients. R3 should only receive one copy of all routes sent from R4.Which configuration is valid?
What does the Junos command advertise-inactive allow?
What does the Junos command advertise-inactive allow?
Which statement is true?
Refer to the Exhibit.
In the exhibit, all routers within each AS are configured for Anycast RP. All intra-AS routers are configured within the same MSDP mesh group. Inter-AS multicast has been enabled using MSDP without MSDP mesh groups. Which statement is true?
PE1’s loopback is 192.168.3.1 and PE2’s loopback is 192.168.4.1.Referring to the output in the exh
Refer to the Exhibit.
Customer A is complaining that routes advertised from the CE2 router are not being received on the CE1 router. The physical topology of the network is CE1-PE1-PE2-CE2. The CE1-PE1 subnet is 172.16.1.0/24. The CE2-PE2 subnet is 172.16.2.0/24. PE1’s loopback is 192.168.3.1 and PE2’s loopback is 192.168.4.1.Referring to the output in the exhibit, what is the problem?
Based on the output in the exhibit, which statement is correct?
Refer to the Exhibit.
Based on the output in the exhibit, which statement is correct?
All other traffic leaving Area 49.0001 must use R4.Which three steps will accomplish this task? (Choose three.
Refer to the Exhibit.
In the exhibit, network 172.16.0.0/16 is redistributed into IS-IS in Area 49.0002. R1 must use R2 to access 172.16.0.0/16. All other traffic leaving Area 49.0001 must use R4.Which three steps will accomplish this task? (Choose three.)