what needs to be done to resolve this problem?
You are troubleshooting a problem where external routes are not being summarized into the OSPF backbone.
Referring to the exhibit, what needs to be done to resolve this problem?
What is causing the problem?
Referring to the exhibit, an administrator has configured dot1q-tunneling on the VLAN, but
LLDP is not being tunneled.
What is causing the problem?
what is causing this problem?
You are asked to troubleshoot a problem with MSTP and determine why Switch-1 and Switch-2
think they are the root bridge for the same MSTI instances. Switch-1 should be the root bridge for
the MSTI 1 instance and Switch-2 should be the root bridge for the MSTI 2 instance. Referring to
the exhibit, what is causing this problem?
What would cause this output?
Interface ge-0/0/12 on Switch1 is connected to ge-0/0/12 on Switch2. You have configured both
Switch1 and Switch2 to run MSTP. You see the CLI output shown in the exhibit.
What would cause this output?
What would cause this problem?
Referring to the exhibit, an administrator notices that the VLAN interface is not coming up. What
would cause this problem? Click the Exhibit to see a larger version. 
Which two configuration mistakes apply?
You have configured OSPF between two routers and the adjacency is not coming up. You confirm
that the physical link between them is up and then run the commands shown in the exhibit on both routers.
Which two configuration mistakes apply? (Choose two.)
Which two configuration changes on R2 would resolve the problem?
Referring to the exhibit, the prefix 3.3.3.3/32 is not in R1 ‘s routing table.
Which two configuration changes on R2 would resolve the problem? (Choose two.)
What is causing this behavior?
Referring to the exhibit, an administrator is trying to advertise a direct route to its neighbor.
The route is not advertised. What is causing this behavior?
Which command will show this information?
The exhibit shows the BGP configuration for a router.
The router should be receiving an identical set of prefixes over its two peering sessions. You want to ensure the router is using both routes for forwarding. Which command will show this information?
Which BGP group configuration parameter will enable you to receive routes from the remote EBGP peer?
You want to receive routes from a remote EBGP peer as shown in the exhibit. The remote site has
the same AS number as your own. You have successfully established the EBGP peering, but are
not receiving any routes. 
Which BGP group configuration parameter will enable you to receive routes from the remote EBGP peer?