You use static routes for connectivity to the ISP. Your ISP recently switched to using
different links for multicast and unicast traffic. Following the change, users in your company
were unable to receive multicast traffic through the ISP. What must you configure on your
router to reestablish multicast connectivity to your ISP?

— Exhibit — — Exhibit — Click the Exhibit button. Referring to the exhibit, what is preventing
the OSPF neighborship with two directly connected routers using interface ge-1/0/3 from
reaching the full state?

— Exhibit — — Exhibit — Click the Exhibit button. Referring to the exhibit, why are the OSPF
routes missing from the routing table for this router?

— Exhibit – — Exhibit — Click the Exhibit button. Referring to the exhibit, you are configuring
an OSPF network. All OSPF adjacencies come up and stay stable. But neither R1 nor R2
has the prefix 200.200.200.200/32 in its routing table. What is causing this problem?

— Exhibit – — Exhibit — Click the Exhibit button. You are troubleshooting an OSPF adjacency
problem between R1 and R2. Referring to the exhibit, what is causing this OSPF adjacency
problem?

— Exhibit — — Exhibit — Click the Exhibit button. You notice that there is a problem with the
OSPF adjacency between two routers, R1 and R2. The relevant system logs from R1 are
shown in the exhibit. What would cause this behavior?

— Exhibit — — Exhibit — Click the Exhibit button. You are trying to establish an OSPF
adjacency between R1 and R2, but the adjacency does not establish. Referring to the
exhibit, what is causing the adjacency to fail?

— Exhibit – — Exhibit — Click the Exhibit button. You are asked to configure a multihop
EBGP peering to a loopback address of your ISP. The peering does not establish, and the
ISP has verified that the settings are correct on their side. Referring to the exhibit, what is
causing the problem?

— Exhibit — — Exhibit — Click the Exhibit button. Referring to the exhibit, what is causing the
IPv4 BGP peering to stay in an active state?

— Exhibit — — Exhibit — Click the Exhibit button. You are troubleshooting a problem where
an EBGP route is not being advertised to your local IBGP peers. You have received a
10.222.1.3/32 route from an EBGP peer as shown in the exhibit, but the route is not being
advertised. What is causing the problem?